Testing Fibers
80 OX1
Performing Tests When Light Is Detected on the Network
The application can detect several link elements or faults that are too close
to one another to be independently identified. When this is the case, the
application will display the link elements as groups and provide as much
information as possible for each individual sub-element. The application
will also apply a pass/fail status to each sub-element whenever possible,
and a global status for the group.
Performing Tests When Light Is Detected on
the Network
When you work with networks on which light is detected, the Optical
Xplorer models offering the 1650 nm wavelength with a filtered port are
more appropriate because they are equipped with a reception filter which
rejects incoming light.
In both cases, if the amount of light that hits the Optical Xplorer detector is
too important, the unit displays a message to notify you.
Group
Global status for the group
To Next Page
Loading...
