Troubleshooting
176 OX1
Restoring Your Unit to Normal Operation
9. Place the back panel on the unit, making sure that it is aligned properly
with the front of the unit. The sides of the back panel should be flush
with those of the front. There should be no gap between the back
panel and the front of the unit. If necessary, slightly move the back
panel until alignment is correct.
10. Using a 2.5 mm hex socket screwdriver, turn the screws (4) clockwise
until they are tightened.
This will secure the back panel into place.
11. Turn your unit over so that you can see its touchscreen.
To Next Page
Loading...
