DMP 128 Plus • Audio Control Panels 104
5. In the panel graphic on the left side of the Configure ACPs dialog box, the mute
button labeled OFF is highlighted (yellow). When a button is highlighted, it is selected for
configuration.
6. From the Control Type drop-down (see figure 170,
4
below), select either:
• Action-Fixed for the OFF button to unmute all output.
• Action-Follow Selector for the OFF button to unmute a group defined by a
selector button.
If Action-Fixed was chosen:
a. From the Mute Master drop-down (
5
), select the mute group containing all
output channels.
If Action-Follow Selector was chosen, the button is fully configured.
7. From the panel graphic on the left side of the dialog box, select the mute button labeled
ON (
6
).
8. From the Control Type drop-down (
7
), select either:
• Action-Fixed for the ON button to mute all output.
• Action-Follow Selector for the ON button to mute a group defined by a selector
button.
NOTE: The same control type chosen for the OFF mute button should be chosen for
the ON mute button.
If Action-Fixed was chosen:
a. From the Mute Master drop-down (
8
), select the mute group containing all
output channels.
If Action-Follow Selector was chosen, the button is fully configured.
Figure 170. Configuring Mute Off and Mute On Buttons
figure 170 Configuring Mute Off and On
To Next Page
Loading...
