·100·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Facing cycle
Level 5:
I: Penetration step (pass) when roughing:
• If programmed with a positive value, the actual step (pass) will be the one closest
to this value and all the passes will be identical.
• If programmed with a negative value, the actual pass will be the one programmed
and the last pass will be adjusted to the final (remaining) depth.
• If not programmed, it assumes 0.
Fx: Penetration feedrate for roughing and finishing. If not programmed, it assumes F/2.
Icon for selecting the machining plane (XC plane or XY plane).
Profile program : Number of the part-program where the pocket is defined.
Dz: Safety distance on the longitudinal axis.
Z: Z coordinate of the part surface.
P: Total profile pocket depth. If not programmed or programmed with a 0 value,
the CNC will display the corresponding error message.
I: Maximum roughing pass. If not programmed or if programmed with a 0
value, it assumes the value of 75% of the diameter of the roughing tool.
Fz: Machining feedrate along the Z axis. If not programmed or programmed with
a 0 value, the CNC assumes the roughing F value for the penetration in
roughing and the finishing F for the penetration in finishing.
W: Angular position of the spindle (in degrees) where the profile will be
machined in the XY plane (in degrees).
Spindle turning direction
To Next Page
Loading...
