Fagor 8055i FL EN - OPERATING IN JOG MODE; 2.1.3 Selecting a program for simulation or execution

·38·
Operating manual
CNC 8055
CNC 8055i
2.
OPERATING IN JOG MODE
·TC· OPTION
SOFT: V02.2X
Introduction
2.1.3 Selecting a program for simulation or execution
When selecting a part-program or operation saved as part of a part-program for simulation or
execution, the CNC selects that part-program and shows it highlighted next to the green "start"
symbol in the top center window.
When the top center window shows the part-program selected next to the green "start" symbol, the
CNC acts as follows:
• If [START] is pressed, the CNC executes the part-program that is selected.
• If [CLEAR] is pressed, the CNC de-selects the part-program and removes it from the top center
window.
15:28:42
X
Z
S
00044.000
-00443.331
115
REFERENCE ZERO X 0000.000
F 0100.000
% 080
T 02
S 0100
D 12
CHANGE POSITION
X 25.000 Z 85.000
% 115
SMAX 1000
RANGE 1
P000002
REFERENCE ZERO Z 0000.000
15:28:42
M0
(MSG " " )
(IF P102 EQ 1 GOTO N10)
(IF P101 EQ 0 RET)
M3
(RET)
N10 M4
(RET)
G01 G18
M41
PARTC : 000000
CYTIME : 00:00:00:00
TIMER: : 000000:00:00
COMMAND
X 00020.000
Z 00000.000
THEORETICAL
ACTUAL
X 00020.000
Z 00000.000
RPM M/MIN
TO GO
X 00000.000
Z 00000.000
X 00000.000
Z 00000.000
FOLLOWING ERROR
S 0.0000 S 0.0000 S 0.0000 S 0.0000
P000002