Fagor 8055i FL EN - OPERATING IN JOG MODE; 2.9.1 Spindle in rpm

Operating manual
CNC 8055
CNC 8055i
OPERATING IN JOG MODE
2.
·TC· OPTION
SOFT: V02.2X
·65·
Spindle control
2.9.1 Spindle in rpm
The CNC displays the following information.
1. Real spindle speed in rpm.
2. Theoretical spindle speed in rpm.
To select another speed, press the [S] key. The CNC highlights the current value.
Enter the new value and press [START]. The CNC assumes that value and refreshes the real
spindle speed.
3. Spindle status.
To modify the spindle status, press the following keys:
4. Percentage of the theoretical spindle speed being applied.
To modify the percentage (%), press the following keys.
5. Maximum spindle speed in rpm.
To select another speed, press the [S] key twice. The CNC highlights the current value. Enter
the new value and press [ENTER]. The CNC assumes this value and does not allow the spindle
to exceed these rpm.
The maximum spindle speed is saved in the MDISL variable. This variable is updated (refreshed)
changing the SMAX value and when programming function "G92 S" via ISO.
Spindle clockwise
Spindle counterclockwise
Outside rounding
15:28:42 SBK P000002 IN POSITION
X
Z
S
00044.000
-00443.331
115
HOME X 0000.000
HOME Z 0000.000
F 0100.000
% 080
T 02
S 0100
D 12
CHANGE POSITION
X 25.000 Z 85.000
% 115
SMAX 1000
RANGE 1
1
2
3 4
5
6
SPINDLE
SPEED
%
+
-
%+
%-
SPINDLE
SPEED
%
+
-