Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; 3.1 Operation editing mode

Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·77·
Operation editing mode
3.1 Operation editing mode
Once the operation has been selected, the CNC shows a screen like the following:
1. Name of the selected operation or work cycle.
2. Help graphics.
3. Spindle conditions to execute the cycle.
4. Current machine status. Coordinates and machining conditions.
5. Data defining the machining geometry.
6. Machining conditions for the roughing operation.
7. Machining conditions for the finishing operation.
The CNC will highlight an icon, a coordinate or one of the data defining the operation or cycle
indicating that it has been selected. Use the following keys to select another icon, data or coordinate.
The coordinates for the X axis are defined in the work units, radius or diameter. Later on, each
operation or cycle indicates the units used to define the data associated with the X axis (safety
distance, pass, excess stock, etc.).
The CNC selects the previous one or the next one.
The CNC selects the first coordinate for that axis. Pressing that key again
selects the next coordinate for that axis.
The CNC selects the corresponding roughing data. Pressing that key again
selects the corresponding finishing data.
The CNC selects the "S" roughing data. Pressing that key again selects the
finishing "S" data and pressing it again selects the data for the spindle SMAX.
15:28:42
Coordinate (Xi, Zi)
X 0.0000 Z 0.0000
Z
X

Xf, Zf
Xi, Zi


Coordinate (Xf, Zf)
X 0.0000 Z 0.0000
TURNING CYCLE
Diameter

0.0000
Safety distance
X 0.0000 Z 0.0000
X 00044.000 Z -00397.490
F 1.000 S 150 T 3
F 0.000 S 150 T 3
ROUGHING
 0
F 0.000 S 150 T 3
FINISHING
z 0
x 0
RPM
GEAR
SMAX 1230
2
1
2
3
4
5
6
7
>
/<
]
[
X
AR
EY
Z
J"
F
Q!
T
NÑ
S