Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; 3.4 Turning cycle

·86·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Turning cycle
3.4 Turning cycle
Turning levels 1 and 2
Level 1.
The following data must be defined:
• Coordinates of the starting point.
• Coordinates of the last point.
• The final diameter.
• The safety distance.
Level 2.
The following data must be defined:
• Coordinates of the starting point.
• Coordinates of the last point.
• The final diameter.
• The type of machining at each corner.
• The safety distance.
This key accesses the turning cycle.
This cycle may be defined in several ways:
Z
X

Xf, Zf
Xi, Zi

