Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·165·
Profiling cycle
3.11.7 Basic operation at levels 3 and 4. XC, ZC profiles
The machining steps in this cycle are as follows:
1. If the operation has been programmed with another tool, the CNC will change the tool and will
move to the change position if so required by the machine.
2. The tool approaches in rapid up to the starting point, (X, Z) keeping the safety distance selected
as per axes X and Z.
3. The spindle orients to the indicated "C" position.
4. Roughing operation, with successive passes, up to a distance from the profile equal to the
finishing stock.
5. Finishing operation.
If the finishing operation has been programmed with another tool, the CNC will change the tool
and will move to the change position if so required by the machine.
Finishing of the bottom of the profile removing the bottom excess stock (
x or z). Then finishing
of the side wall, removing the excess stock in successive passes.
The finishing of the part is carried out with the machining conditions set for finishing; feedrate
of the axes (F), speed of the live tool.
6. Once the operation or cycle has ended, the tool will return to the position it occupied when calling
the cycle; i.e. to the point where [START] was pressed.
When executing an entire part, combination of operations or cycles, the tool does not return to
that point after executing each cycle.
To Next Page
Loading...
