·30·
Operating manual
CNC 8055
CNC 8055i
1.
GENERAL CONCEPTS
·TC· OPTION
SOFT: V02.2X
Power-up
1.3 Power-up
The standard screen of the TC mode is the following:
On power-up and after the keystroke sequence [SHIFT] [RESET], the CNC shows
"page 0" defined by the manufacturer; if there is no "page 0", it shows the standard
screen of the work mode. Press any key to access the work mode.
There are 2 work modes: TC work mode and T work mode. To change from one
work mode to another, press the key sequence [SHIFT] [ESC].
15:28:42 SBK P000002 IN POSITION
X
Z
S
00044.000
-00443.331
0
REFERENCE ZERO X 0000.000
REFERENCE ZERO Z 0000.000
00025.000
00000.013
00014.480
F 0100.000
% 080
T 02
S 0100
D 12
CHANGE POSITION
X 25.000 Z 85.000
% 115
SMAX 1000 RANGE 1
020.0000
The CNC setup must be done in T mode.
Likewise, some errors must be eliminated in T mode.
To Next Page
Loading...
