Operating manual
CNC 8055
CNC 8055i
OPERATING IN JOG MODE
2.
·TC· OPTION
SOFT: V02.2X
·39·
Axis control
2.2 Axis control
2.2.1 Work units
When accessing the TC mode, the CNC assumes the work units «mm or inches", «mm/min. or
mm/rev», «radius or diameter» etc. selected by machine parameter.
To modify those values, access the T mode and change the corresponding machine parameter.
2.2.2 Coordinate preset
The coordinates must be preset on one axis at a time proceeding as follows:
1. Press the key of the desired axis, [X] or [Z].
The CNC will highlight the coordinate of that axis indicating that it is selected.
2. Key in the value to preset the axis.
To quit the preset mode, press [ESC].
3. Press [ENTER] for the CNC to assume that value as the new value for the point.
The CNC requests confirmation of the command. Press the [ENTER] to confirm it or [ESC] to
quit the preset mode.
2.2.3 Managing the axis feedrate (F)
To set a particular axis feedrate value, proceed as follows:
1. Press the [F] key.
The CNC will highlight the current value that it is selected.
2. Key in the desired new feedrate value.
To quit the preset selection mode, press [ESC].
3. Press [START] for the CNC to assume that value as the new value for axis feedrate.
To Next Page
Loading...
