·44·
Operating manual
CNC 8055
CNC 8055i
2.
OPERATING IN JOG MODE
·TC· OPTION
SOFT: V02.2X
Jog movement
2.5.4 Path-jog
The "path jog" mode acts when the switch is in one of the continuous or incremental jog positions.
This feature may be used to act upon the jog keys of an axis to move both axes of the plane at the
same time for chamfering (straight sections) and rounding (curved sections). The CNC assumes
as "Path jog" the keys associated with the X axis.
While in jog mode and having selected path-jog, the CNC shows the following information:
For a linear movement (top figure), the path angle must be defined and for an arc (bottom figure),
the center coordinates must be indicated. To define these variables, press the [F] key and then one
of these keys: [] [] [] [].
This feature must be managed from the PLC. This feature is usually activated and deactivated by
means of an external push-button or a key configured for that purpose, as well as the selection of the
type of path.
The next example uses the [O2] key to activate and deactivate the path-jog mode and the
[O3] key to indicate the type of movement.
Activate / deactivate the path-jog mode.
DFU B29 R561 = CPL M5054
It selects the type of movement, straight section or arc section.
DFU B31 R561 = CPL M5053
To Next Page
Loading...
