Operating manual
CNC 8055
CNC 8055i
OPERATING IN JOG MODE
2.
·TC· OPTION
SOFT: V02.2X
·49·
Tool control
2.6 Tool control
The standard screen of the TC mode offers the following tool data.
This window displays the following information:
• In large characters, the tool "T" number currently selected and a graphic representation of its tip.
• The "D" offset number associated with the tool.
• The "S" rpm that are selected for the live tool. This value is only shown when a live tool has been
selected.
• The position values of the tool change point. The CNC does not show this window when text
47 of program 999997 has not been defined.
To select another tool, follow these steps:
1. Press the [T] key.
The CNC highlights the tool number.
2. Key in the number of the tool to be selected.
To quit the preset selection mode, press [ESC].
3. Press [START] for the CNC to select the new tool.
The CNC will manage the tool change. Once the new tool has been selected, the CNC refreshes
the graphic representation for the location code (shape) associated with the new tool.
Another offset may be assigned to the tool temporarily without modifying the one associated with it.
1. To access the "D" field, press [T] and [].
2. Key in the number of the desired tool offset and press [START].
The CNC temporarily assumes the new offset for the current tool. The internal table is not
modified, the tool’s associated offset is still the one assigned to it when it was calibrated.
To Next Page
Loading...
