Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·85·
Positioning cycle
3.3.1 Definition of data
Order in which the axes move.
Type of feedrate.
Coordinates of the target point (X, Z).
The coordinates are defined one by one. After placing the cursor on the coordinates of the axes to
be defined, the value is entered in one of the following ways.
• Entering the value manually. Key in the desired value and press [ENTER].
• Assign the current machine position.
Jog the axis with the handwheel or the JOG keys up to the desired point. Press [RECALL] so
the selected data assumes the value shown in the top right window and press [ENTER].
The top right window shows the tool position at all times.
Auxiliary "M" functions.
Auxiliary function “M” is the name given to the functions determined by the manufacturer which allow
the different machine devices to be governed. Some auxiliary "M" functions are used to interrupt
the program, to select the spindle turning direction, to control the coolant, the spindle gear box, etc.
The programming manual describes how to program these functions and the installation manual
describes how to set up the system to use them.
To define the auxiliary functions, select the corresponding window with the [][] keys. Use the
[][] keys to move around the window. To delete a function, select it and press [CLEAR]
The functions will be executed in the same order as these are arranged on the list.
To select the moving order, place the cursor over this icon and press the two-color key.
All two axes at the same time.
First X and then Z.
First Z and then X.
To select the type of feedrate, place the cursor over this icon and press the two-color key.
Programmed feedrate.
Rapid feed.
To Next Page
Loading...
