Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·159·
Profiling cycle
3.11.3 Level 2. Optimizing of the machining of a profile
If only the desired profile is defined, the CNC assumes that the original stock is cylindrical and
machines it as shown on the left.
When the part profile is known, it is recommended to define both profiles, that of the rough part and
the desired final profile. The machining is faster since only the stock between both profiles is
removed.
To define both profiles, proceed as follows:
1. Access the profile editor.
2. Edit the desired final profile.
3. Press the softkey for a new profile.
4. Edit the rough part profile.
5. Exit the profile editor saving the profile.
Remember that the final profile must be defined first and then the rough profile.
To Next Page
Loading...
