·192·
Operating manual
CNC 8055
CNC 8055i
6.
SAVING PROGRAMS
·TC· OPTION
SOFT: V02.2X
Modify a part-program
6.7 Modify a part-program
To modify a part-program, proceed as follows:
1. Press [P.PROG] to access the list of part-programs stored.
2. Select, with the pointer, the part-program to be modified from the left column.
Once the program has been selected, the following operations are possible:
• To delete an operation.
• To move an operation to another position.
• To add or insert a new operation.
• To modify an existing operation.
6.7.1 Delete an operation
To delete an operation, proceed as follows:
1. Select, with the pointer, the operation to be deleted from the right column.
2. Press [CLEAR].
The bottom of the screen will show a message requesting confirmation of the deleting operation.
• If [ENTER] is pressed, the CNC will delete the selected operation and will update the right
column.
• If [ESC] is pressed, the operation will not be deleted and it will quit deleting operation.
6.7.2 Add or insert a new operation
To add or insert an operation follow the same steps as for saving an operation.
1. Define the desired block or cycle assigning the relevant data to it.
2. Press [P.PROG] to access the list of part-programs stored.
3. Place the pointer on the operation after which the block or cycle is to be saved and press
[ENTER].
To Next Page
Loading...
