Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; 3.4.2 Data definition (levels 3, 4 and 5)

Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·91·
Turning cycle
3.4.2 Data definition (levels 3, 4 and 5)
Level 3:
Level 4:
Icon for selecting the ZC or YZ plane.
Icon to select the position of the starting point.
Z,C / Z,Y: Coordinates of the starting point.
L, H: Pocket dimensions.
: Inclination angle of the rectangular pocket.
W: Angular position of the spindle (in degrees) where the pocket will be milled in the YZ
plane.
Icon for selecting the vertex type in the pocket corners:
•Normal vertix
• Rounded vertix
• Chamfered vertix
r / c: Value of the corner rounding or chamfering radius in the rectangular pocket.
Dx: Safety distance on the longitudinal axis (cylindrical side).
Dz: Safety distance on the longitudinal axis (face).
X: Part plane.
P: Total rectangular pocket depth. When programmed with a 0 value, it generates the
corresponding error.
I: Penetration step (pass) when roughing:
• If programmed with a positive value, the actual step (pass) will be the one closest
to this value so all passes will be identical.
• If programmed with a negative value, the actual pass will be the one programmed
and the last pass will be adjusted to the final (remaining) depth.
• If not programmed, it assumes 0.
Fx: Penetration feedrate for roughing and finishing. If not programmed, it assumes 0.
Icon to select the ZC or YZ plane.
Zc, Cc /
Zc, Yc:
Center coordinates of the circular pocket.
Rc: Circular pocket radius.
W: Angular position of the spindle (in degrees) where the pocket will be milled in the YZ
plane.
Dx: Safety distance on the longitudinal axis (cylindrical side).
Dz: Safety distance on the longitudinal axis (face).
R / X: • Cylinder radius when it is the ZC plane.
• X coordinate of the part surface when it is the ZY plane.
P: Total circular pocket depth. When programmed with a 0 value, it generates the
corresponding error.