Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; Type of rounding.; Concave and convex rounding.; Shape of the part before and after the rounded section.

·110·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Rounding cycle
3.7.1 Geometry definition
Type of rounding.
When changing the type of rounding, the CNC changes the icon and shows the corresponding help
screen.
Concave and convex rounding.
Whenever one of these is changed the CNC modifies the icon and displays the relevant geometry
help screen.
Shape of the part before and after the rounded section.
When changing the type of section, the CNC changes the icon and shows the corresponding help
screen.
To select the type of rounding, place the cursor over this icon and press the two-color key.
Inside rounding.
Outside rounding.
The type of section before and after the rounding section is defined with the following
icons. To select the desired type, place the cursor over this icon and press the two-color
key.
Convex rounding / concave rounding.
The type of section before and after the rounding section is defined with the following
icons. To select the desired type, place the cursor over this icon and press the two-color
key.
*
*
*
Z
X
Z
X