Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; 3.6 Taper turning cycle

Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·103·
Taper turning cycle
3.6 Taper turning cycle
Level 1.
The following data must be defined:
• The coordinates of the theoretical corner.
• The inclination angle and the final diameter.
Level 2.
The following data must be defined:
• Coordinates of the starting point.
• Coordinates of the last point.
Level 3.
The following data must be defined:
• The coordinates of the theoretical corner.
• The taper angle and the distance in Z.
This key accesses the taper turning cycles.
This cycle may be defined in two ways:
Z
X
Xi, Zi




Z
X
Xi, Zi


Xf, Zf
Z
X
Xi, Zi



Z