Operating manual
CNC 8055
CNC 8055i
EXECUTION AND SIMULATION
7.
·TC· OPTION
SOFT: V02.2X
·199·
Simulating or executing a part-program
7.2 Simulating or executing a part-program
Proceed as follows to simulate or execute a part-program:
1. Press [P.PROG] to access the list of part-programs stored.
2. Select on the left column the program to be simulated or executed.
Press [GRAPHICS] to simulate the part-program and [START] to execute it. When executing a
program, the CNC executes the initial subroutine 9998 and the final subroutine 9999.
If an error occurs in a cycle during simulation or execution, when accessing the list of programs
again, the cursor will be placed on the cycle that came up with the error. When program 999998
is displayed on the screen or the error is not an execution error, the cursor will go to the beginning
or to the end of the program depending on its length.
7.2.1 Simulating or executing a portion of a part-program
Proceed as follows to simulate or execute a portion of a part-program:
1. Press [P.PROG] to access the list of part-programs stored.
2. Select the program from the left column and the operation (on the right column) from which to
begin executing or simulating the part program.
Press [GRAPHICS] to simulate the selected portion and [START] to execute it. When executing a
portion of a program, the CNC does not execute the initial subroutine 9998, but it executes the final
subroutine 9999. If the program is executed from the first operation on, it executes both subroutines.
To Next Page
Loading...
