Fagor 8055i FL EN - OPERATING IN ISO MODE; 5.2 Programming assistance

Operating manual
CNC 8055
CNC 8055i
OPERATING IN ISO MODE
5.
·TC· OPTION
SOFT: V02.2X
·183·
Programming assistance
5.2 Programming assistance
5.2.1 Zero offsets and presets
5.2.2 Work zones
5.2.3 Insert labels and repetitions from label to label
The icon may be used to select the following options:
• Machine zero. It cancels any zero offset and assumes the
machine zero (home) as reference.
• Absolute zero offset. It permits defining, enabling or defining +
enabling the absolute zero offsets (G54 ... G57, G159N7 ...
G159N20).
• The zero offset is selected with an icon.
• Incremental offset: It permits defining, enabling or defining +
enabling the incremental zero offsets (G58 or G59). The zero
offset to be activated is selected with an icon.
• Preset: The preset value for the active axes may be edited on
the screen. If you do not wish to preset any of them, leave its field
empty (blank).
The cycle internally generates a block with function G53,
G54...G59, G159N7...G159N20 or G92.
Pressing the [ZERO] key accesses the zero offset table.
(x,z)
X
Z
The icons may be used to defined the following options:
• Select the work zone to act upon. Up to five different zones may
be defined.
• Type of action to carry out with the zone. A zone may be defined,
enabled, defined+enabled or disabled.
• Define the type of zone. Each one of them may be defined either
as a no-entry or no-exit zone.
The numeric fields permit editing the lower and upper limits of the
zone. The limits are defined on the X and Z axes. To only define
either the upper or the lower limit, leave the values of the other limit
blank.
The cycle internally generates up to three blocks with functions
G20, G21 and G22.
X
Xs
Zi Zs
Xi
Z
This cycle permits editing labels and repetition blocks between two
labels. It is selected with an icon.
• Edit labels. There is a field to enter the block number an another
one to add a comment.
The cycle generates this type of a block: N10; -> Comment
• Block repetition. The repetition takes place between the first and
final labels programmed, the number of times that is indicated.
The cycle internally generates an RPT block.
N10 ; ABC . . .
5
N20 ; ABC . . .
(RPT N10, N20) N5