Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; 3.9 Grooving cycle

·136·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Grooving cycle
3.9 Grooving cycle
Level 1. Grooving on the cylindrical side.
The following data must be defined:
• The coordinates of the first and last points.
• The final diameter.
• The dwell at the bottom.
• Number of grooves and offset.
Level 2. Face grooving.
The following data must be defined:
• The coordinates of the first and last points.
• The coordinate of the bottom of the groove.
• The dwell at the bottom.
• Number of grooves and offset.
Level 3. Grooving on the side of the cylinder with incline walls.
This key accesses the grooving cycles.
This cycle may be used to groove on the cylindrical side of the part or on its face, all of
them with vertical walls or incline walls.
Z
X

Xf, Zf
Xi, Zi


t
T
Z
X

Xf, Zf
Xi, Zi

t
T
R
Z
X

Xf, Zf
Xi, Zi


T


1
23
4