Fagor 8055i FL EN - EXECUTION AND SIMULATION; 7.1 Simulating or executing an operation or cycle

·198·
Operating manual
CNC 8055
CNC 8055i
7.
EXECUTION AND SIMULATION
·TC· OPTION
SOFT: V02.2X
Simulating or executing an operation or cycle
7.1 Simulating or executing an operation or cycle
All the operations or cycles have 2 work modes; execution and editing.
Simulation
Execution
An operation or cycle can only be executed in the cycle execution mode.
The operation or cycle cannot be executed when the cycle editing mode is selected. Press [ESC]
to quit the editing mode and switch to execution mode.
The operation or cycle may be simulated in both work modes. To do that, press the
[GRAPHICS] key. The CNC shows the graphic screen of the T model.
Press [START] to execute an operation or cycle.
15:28:42
Coordinate (Xi, Zi)
X 0.0000 Z 0.0000
Z
X

Xf, Zf
Xi, Zi


Coordinate (Xf, Zf)
X 0.0000 Z 0.0000
TURNING CYCLE
Diameter

0.0000
Safety distance
X 0.0000 Z 0.0000
X 00044.000 Z -00397.490
F 1.000 S 150 T 3
F 0.000 S 150 T 3
RPM
SMAX 0
ROUGHING ROUGHING PASS

0
F 0.000 S 150 T 3
FINISHING FINISHING STOCK

0
15:28:42
Coordinate (Xi, Zi)
X 0.0000 Z 0.0000
Z
X

Xf, Zf
Xi, Zi


Coordinate (Xf, Zf)
X 0.0000 Z 0.0000
TURNING CYCLE
Diameter

0.0000
Safety distance
X 0.0000 Z 0.0000
F 0.000 S 150 T 3
RPM
SMAX 0
ROUGHING ROUGHING PASS

0
F 0.000 S 150 T 3
FINISHING FINISHING STOCK

0
Editing mode Execution mode
GRAPHICS