Fagor 8055i FL EN - OPERATING IN ISO MODE; 5.1 Editing blocks in ISO mode

·182·
Operating manual
CNC 8055
CNC 8055i
5.
OPERATING IN ISO MODE
·TC· OPTION
SOFT: V02.2X
Editing blocks in ISO mode
5.1 Editing blocks in ISO mode
When accessing the ISO mode, the CNC displays a special screen for editing up to 6 program blocks
either in ISO code or in high level language. After editing a block, press [ENTER] to validate it.
Once the block or blocks have been edited, press [ESC]. The upper right side of the screen will show
the "start" symbol. From this moment one, the edited blocks may be simulated, executed or saved
like any operation or cycle.
G95 G96 S120 M3
G0 Z100
G1 X30 F0.1
Example:
ISO
ENTER
ENTER
ENTER