Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; 3.2.1 Background cycle editing

Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·83·
Simulating and executing the operation
3.2.1 Background cycle editing
It is possible to edit an operation or cycle while executing a program or part (background editing).
The new operation edited may be saved as part of a part-program other than the one being executed.
The operation being edited in background cannot be executed or simulated, and the current position
of the machine cannot be assigned to a coordinate.
Use the following keys to inspect or change a tool while editing in background.
Pressing the [T] key without quitting background editing selects the T field of the operation or of the
canned cycle being edited.
Interrupts the execution and goes on editing in background.
To quit background editing.
To access tool inspection.
ESC
Q!
T
Background editing is not possible while executing an independent operation or cycle. It can only be
done while executing a program or part.
i