Operating manual
CNC 8055
CNC 8055i
OPERATING IN JOG MODE
2.
·TC· OPTION
SOFT: V02.2X
·53·
Tool calibration
2.7.1 Define the tool in the tool table (level 1)
When accessing this level, the CNC shows the following screen.
1. Indicating the selected work mode: "Tool calibration".
2. Graphic assistance for tool calibration.
3. Help graphics for defining tool geometry.
4. Current machine status.
Real X Z coordinates, real axis feedrate F, real spindle speed S and currently selected tool T.
5. Tool number, tool offset number, location code (shape) and tool family.
6. Length values defined for this tool.
7. Values for the geometry of the tool.
Define the tool data
Proceed as follows to define a tool in the tool table:
Select the number of the tool to be defined.
1. Press the [T] key to select the "T" field.
2. Key in the desired tool number and press [RECALL].
If the tool is defined, the CNC will show the values stored in the table. If the tool is not defined,
the CNC assigns an offset with the same number to it and all the data is reset to 0.
Select the number of the offset tool to be associated with this tool.
1. The "D" field must be selected. If it is not, use the [] key.
2. Key in the desired offset number to be associated with the tool and press [ENTER].
Define the tool dimensions.
The data for the tool is the following.
Even if the tool dimensions are known, it is recommended to measure it. See "2.7.2 Manual tool
calibration with/without a probe (level 1)" on page 56.
Once it is measured, the CNC updates the X, Z fields and sets the I and K data to 0.
To define these values, select the corresponding field with the [] [] [] [] keys, key in the desired
value and press [ENTER].
To Next Page
Loading...
