·78·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Operation editing mode
3.1.1 Definition of spindle conditions
Work mode (RPM) or (CSS)
Place the cursor on the "RPM" or "CSS" icon. To do this, use the [CSS] key or the [] [] [] [] keys.
Once the data has been selected, press the [CSS] key or the two-color key to change the work mode.
Spindle range
Place the cursor over this data, key in the desired value and press [ENTER].
In cycles using a live tool:
Maximum spindle speed (S) in rpm
Place the cursor over this data, key in the desired value and press [ENTER].
Spindle turning direction
There are two ways to select the spindle turning direction.
Coolant
There are two ways to turn the coolant on or off.
Once the operation or the cycle is completed or the part-program it belongs to, the CNC outputs
the M9 function to the PLC.
Icon for selecting the spindle gear to be used for machining cycles where a live tool is
used. Its possible values are:
Value 0: Gear corresponding to the S value
Value 1: Gear 1
Value 2: Gear 2
Value 3: Gear 3
Value 4: Gear 4
Place the cursor on this data and press the two-color key to change the icon.
Start the spindle in the desired direction with the JOG keys. The CNC starts the
spindle and assumes that turning direction as spindle turning data for the cycle.
Place the cursor on this data and press the two-color key to change the icon.
Turns the coolant on. The CNC outputs the M8 function to the PLC.
Turns the coolant off. The CNC outputs the M9 function to the PLC.
To Next Page
Loading...
