Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·79·
Operation editing mode
3.1.2 Definition of machining conditions
Some operations keep the machining conditions throughout the execution (positioning cycles,
drilling cycle, etc.). Other operations use some machining conditions for roughing and others for
finishing (turning cycle, rounding cycle, etc.).
This section describes how to define all this data.
Selecting the roughing operation.
Place the cursor on the roughing checkbox, select or de-select the roughing operation pressing the
[TWO-COLOR] key and press [ENTER]. When de-selecting the roughing, all its data will stay in gray.
The data "side finishing stock" of the finishing portion is turned on/off using the roughing checkbox
Selecting the finishing operation.
Place the cursor on the finishing checkbox, select or de-select the finishing operation pressing the
[TWO-COLOR] key and press [ENTER]. When de-selecting the finishing, all its data will stay in gray.
Axis feedrate (F).
Spindle turning speed (S).
Machining tool (T).
Place the cursor over this data, key in the desired value and press [ENTER].
The CNC updates the associated offset (D) and refreshes the associated icon showing the graphics
for the location code (shape) of the new tool.
Press [ESC] to quit the tool calibration mode and return to the cycle
Tool offset number (D).
Place the cursor over this data, key in the desired value and press [ENTER].
Place the cursor over this data, key in the desired value and press [ENTER].
Place the cursor over this data, key in the desired value and press [ENTER].
It is also possible to access the tool calibration mode to check or modify the data for the
selected tool. To do that, place the cursor on the "T" and press the key associated with
tool calibration.
Pocket machining direction.
Icon to set the machining direction of the roughing tool.
To Next Page
Loading...
