Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; Machining direction.; Auxiliary M functions.

·80·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Operation editing mode
Machining direction.
Some cycles allow the machining direction to be selected (turning direction or facing direction).
Roughing pass (  ).
Finishing stock (
 ).
Sideways penetration angle (
 ,  ).
Sideways penetration angle. If programmed with a value smaller than or equal to 0º, or greater than
90º, it issues the corresponding error message. If not programmed, it assumes 90º.
Auxiliary "M" functions.
There is a window for setting up to 4 auxiliary M functions in the roughing and finishing operations.
The functions will be executed in the same order as these are arranged on the list.
Select the corresponding window with the [][] keys Use the [][] keys to move around the
window.
To delete a function, select it and press [CLEAR]
Place the cursor on this icon and press the two-color key. The icon changes and the help
graphics are refreshed.
Place the cursor over this data, key in the desired value and press [ENTER]. The roughing
pass is always defined in radius.
The roughing pass is always defined in radius. Place the cursor over this data, key in the
desired value and press [ENTER].
Z
X
Xi, Zi
1
2
5
3
4
Z
X
Xi, Zi
1
25
3
4
Turning direction. Facing direction.
*
ENTER
ENTER
The availability of "M" functions in the cycles is determined with g.m.p. "CODISET (P147)".
i