Fagor 8055i FL EN - SAVING PROGRAMS; 6.2 See the contents of a program; 6.2.1 Seeing one of the operations in detail

Operating manual
CNC 8055
CNC 8055i
SAVING PROGRAMS
6.
·TC· OPTION
SOFT: V02.2X
·187·
See the contents of a program
6.2 See the contents of a program
To see the contents of a part-program, select it on the left column using the pointer. To do that, use
the [][] keys. The right column shows the cycles that make up the part.
Once an operation has been selected, the following is possible:
• To see the operation in detail.
• To delete the operation.
• To move the operation to another position.
• To modify the operation.
6.2.1 Seeing one of the operations in detail
In this moment it is possible to:
• Simulate the operation. See chapter "7 Execution and simulation".
• Execute the operation. See chapter "7 Execution and simulation".
• To modify the operation.
• Save the operation. Replacing the previous one or inserting it as a new one.
When pressing [ENTER] or one of the [][] keys, the pointer switches to the right
column. Now, the [][] keys may be used to move the pointer over the blocks or cycles
that make up the part.
ENTER
So, use the [][] keys to move up and down on each column and [][] keys to switch columns.
i
Once the desired operation has been selected using the pointer, press [RECALL]. The
CNC will show all the data for that operation.
RECALL