Fagor 8055i FL EN - SAVING PROGRAMS; 6.7.3 Move an operation to another position

Operating manual
CNC 8055
CNC 8055i
SAVING PROGRAMS
6.
·TC· OPTION
SOFT: V02.2X
·193·
Modify a part-program
6.7.3 Move an operation to another position
To move an operation to another position, proceed as follows:
1. Select, with the pointer, the operation to be moved from the right column.
Example:
Select the "facing cycle" operation and press the two-color key. Then position the cursor on the "taper
turning cycle 1" operation and press [ENTER].
2. Press the two-color key.
The CNC will highlight that operation.
3. Place the cursor on the operation after which the operation is to be placed and press
[ENTER].
Current program Desired program
Positioning cycle 2 Positioning cycle 2
Facing cycle Taper cycle 2
Taper cycle 2 Turning cycle
Turning cycle Rounding cycle 2
Rounding cycle 2 Taper cycle 1
Taper cycle 1 Facing cycle
Threading cycle 1 Threading cycle 1
*