Fagor 8055i FL EN - EXECUTION AND SIMULATION; 7.3 Simulating or executing an operation that has been saved

·200·
Operating manual
CNC 8055
CNC 8055i
7.
EXECUTION AND SIMULATION
·TC· OPTION
SOFT: V02.2X
Simulating or executing an operation that has been saved
7.3 Simulating or executing an operation that has been saved
Proceed as follows to simulate or execute an operation that has been saved as a part of program:
1. Press [P.PROG] to access the list of part-programs stored.
2. Select the program that contains it from the left column and the operation to be simulated or
executed from the right column.
3. Press the [RECALL] key.
Press [GRAPHICS] to simulate the operation and [START] to execute it.