Operating manual
CNC 8055
CNC 8055i
EXECUTION AND SIMULATION
7.
·TC· OPTION
SOFT: V02.2X
·201·
Execution mode
7.4 Execution mode
During execution, both screens show (in the top center window) the number of the program and the
number of the cycle being executed. However, when detecting an RPT or GOTO instruction, the
cycle number will disappear.
When pressing [START] to execute an operation or part-program, the CNC shows the
standard screen of the TC mode.
When pressing the two-color key, the CNC shows the special screen of the TC mode.
15:28:42
X
Z
S
00044.000
-00443.331
115
REFERENCE ZERO X 0000.000
F 0100.000
% 080
T 02
S 0100
D 12
CHANGE POSITION
X 25.000 Z 85.000
% 115
SMAX 1000
RANGE 1
P000002
REFERENCE ZERO Z 0000.000
15:28:42
M0
(MSG " " )
(IF P102 EQ 1 GOTO N10)
(IF P101 EQ 0 RET)
M3
(RET)
N10 M4
(RET)
G01 G18
M41
PARTC : 000000
CYTIME : 00:00:00:00
TIMER: : 000000:00:00
COMMAND
X 00020.000
Z 00000.000
THEORETICAL
ACTUAL
X 00020.000
Z 00000.000
RPM M/MIN
TO GO
X 00000.000
Z 00000.000
X 00000.000
Z 00000.000
FOLLOWING ERROR
S 0.0000 S 0.0000 S 0.0000 S 0.0000
P000002
Once the operation or part has been selected, it may be executed as often as desired;
to do that, once the execution has finished, pressed the [START] again.
To interrupt the execution, press [STOP]. Once the execution has been interrupted,
a tool change may be done. See "7.4.1 Tool inspection" on page 202.
While executing an operation or a part, the [GRAPHICS] key may be pressed to
access the graphics display mode.
To Next Page
Loading...
