Fagor 8055i FL EN - OPERATING IN JOG MODE; 2.5 Jog movement; 2.5.1 Moving an axis to a particular position (coordinate); 2.5.2 Incremental movement

·42·
Operating manual
CNC 8055
CNC 8055i
2.
OPERATING IN JOG MODE
·TC· OPTION
SOFT: V02.2X
Jog movement
2.5 Jog movement
When making a move in manual, both in jog and with handwheels, the moving axis appears in
reverse video.
• With gantry axes, only the master axis is highlighted.
• With a path handwheel, no axis is highlighted; but it is in path-jog.
2.5.1 Moving an axis to a particular position (coordinate)
The movements of axes to a particular coordinate are made one at a time as follows
[X] Target coordinate [START]
[Z] Target coordinate [START]
2.5.2 Incremental movement
Turn the JOG switch to one of the JOG positions.
The incremental movement must be made one axis at a time. To do that, press the JOG keys for
the direction of the axis to be jogged.
Every time a key is pressed, the corresponding axis moves the amount set by the switch. This
movement is made at the selected feedrate (F).
Switch position Distance
1 0.001 mm or 0.0001 inches
10 0.010 mm or 0.0010 inches
100 0.100 mm or 0.0100 inches
1000 1.000 mm or 0.1000 inches
10000 10.000 mm or 1.0000 inches
100
10
1
100
10
1
1000
10000
JOG
100
10
1
100
10
1
1000
10000
JOG