Fagor 8055i FL EN - GENERAL CONCEPTS; 1.4 Working in T mode with the TC keyboard; 1.5 Video off; 1.6 Managing the CYCLE START key

Operating manual
CNC 8055
CNC 8055i
GENERAL CONCEPTS
1.
·TC· OPTION
SOFT: V02.2X
·31·
Working in T mode with the TC keyboard
1.4 Working in T mode with the TC keyboard
The TC keyboard is designed to also be able to work in T mode. In T mode, use the alphanumeric
keyboard and the keys that replace the softkeys F1 through F7.
1.5 Video off
Also, any message (PLC, program, etc.) restores the CNC image.
1.6 Managing the CYCLE START key
In order to avoid undesired executions when pressing key sequences that are not supported in TC
mode, the CNC changes the "Start" icon at the top of the window from green to gray and shows a
message indicating that it is an invalid action.
For example, if "M3 Start" is pressed (sequence not supported in TC mode) while a part-program
is selected, the CNC issues a warning and prevents the selected part-program from running when
detecting the "Start" key.
There are 2 work modes: TC work mode and T work mode. To change from one
work mode to another, press the key sequence [SHIFT] [ESC].
Alphanumeric keyboard:
The keys that replace the softkeys F1 through F7
are:
ESC
SHIFT
ENTER
RECALL
P.PROG
CLEAR
ESC
RESET
EY
Z 4
G(
5
H)
6
I$
X
AR
7
BU
8
CV
9
DW
J"
F 1
K'
2
L;
3
M:
NÑ
S -
+=
0
0?
·
PSP
ALT
Q!
T
SHIFT
]
* /<> [
F1 F7
The keystroke sequence [SHIFT] [CLEAR] clears the CRT screen (it goes blank).
Press any key to restore the image.
CLEAR
SHIFT