Fagor 8055i FL EN - OPERATING IN JOG MODE; 2.9 Spindle control

·64·
Operating manual
CNC 8055
CNC 8055i
2.
OPERATING IN JOG MODE
·TC· OPTION
SOFT: V02.2X
Spindle control
2.9 Spindle control
The standard screen of the TC mode has a window that shows the following spindle related data.
Since it is possible to work with the spindle in rpm, at CSS or in orientation mode, the information
shown by that window will be different in each case.
To switch from one mode to the other, press the key:
On CNC power-up and after the keystroke sequence [SHIFT] [RESET], the CNC selects the rpm
mode. When working at constant surface speed (CSS), the light of the [CSS] key is on.
S 0100
% 115
SMAX 1000
RANGE 1
CSS 0100
% 115
SMAX 1000
RANGE 1
S 0100
% 115
SMAX 1000
RANGE 1
S 0100
% 115
SMAX 1000 RANGE 1
020.0000
CSS rpm without
spindle
orientation
rpm with
spindle
orientation
CSS
m / min
CSS
m / min