Fagor 8055i FL EN - OPERATING IN JOG MODE; 2.3 Machine reference (home) search

·40·
Operating manual
CNC 8055
CNC 8055i
2.
OPERATING IN JOG MODE
·TC· OPTION
SOFT: V02.2X
Machine reference (home) search
2.3 Machine reference (home) search
Home search may be done in 2 ways:
• Homing all the axes.
• Homing a single axis.
Homing all the axes
To home all the axes, press [ZERO].
The CNC requests confirmation of the command (text 48 of program 999997). Press [START], the
CNC will execute the home search subroutine defined by the OEM in general machine parameters
P34 (REFPSUB).
Homing a single axis
To home a single axis, press the key of the desired axis and the key for home search.
In either case, the CNC requests confirmation of the command (text 48 of program 999997).
ZERO
ZERO
After searching home this way, the CNC will maintain the part zero or zero offset active at the time.
A home search subroutine (general machine parameter P34 other than 0) must be defined when using
this method. Otherwise, the CNC will display the corresponding error.
i
It homes the X axis.
It homes the Z axis.
X
AR
ZERO
Z
J"
ZERO
After searching home this way, the CNC will not maintain the part zero or zero offset active at the time
and assumes the machine reference zero as the new part zero.
i