·188·
Operating manual
CNC 8055
CNC 8055i
6.
SAVING PROGRAMS
·TC· OPTION
SOFT: V02.2X
Edit a new part-program
6.3 Edit a new part-program
To edit a new program, proceed as follows:
1. Press [P.PROG] to access the list of part-programs stored.
2. Select, with the pointer, the option "Creating new part" on the left column.
3. Press the [P.PROG] key. The bottom of the screen will request the number to be
assigned to the new part-program and it will offer the first one available.
4. Enter the number of the desired program and press [ENTER].
It must be a number between 1 and 899999. Both included.
5. The CNC requests the comment to be associated with the part-program.
It is not necessary to associate a comment.
6. Press the [ENTER] or [ESC].
The CNC includes the new part-program in the list (left column).
From this moment on, all the desired operations may be saved in the desired order.
To Next Page
Loading...
