Fagor 8055i FL EN - P999997 Text Program Management

Operating manual
CNC 8055
CNC 8055i
GENERAL CONCEPTS
1.
·TC· OPTION
SOFT: V02.2X
·29·
General concepts
1.2.1 P999997 text program management
On power up, the CNC copies the texts of program P999997 into the system memory.
• It checks if program P999997 is in user memory, if not, it looks in the KeyCF and if it is not there
either, it assumes the default ones and copies them into program P999997 of the user memory.
• When selecting mainland Chinese, it ignores program P999997 and it always assumes the
default ones.
If when switching from T mode to TC or TCO mode, it cannot find program P999997 because it has
been deleted, it is initialized like on power-up.
When modifying the texts of program P999997, turn the CNC off and back on so it assumes the
new texts.
The CNC carries out the following operations when changing the language, the software version
and when adding TC, TCO conversational modes (new software features):
• It copies, for safety, the texts that were being used into KeyCF as program P999993.
• It deletes the program P999997 that may be in the KeyCF.
• It assumes the new texts that are provided by default and copies them into program P999997
of the user memory.
To change the texts, after modifying program P999997, turn the CNC off and back on so it assumes
the new texts.