Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; 3.2 Simulating and executing the operation

·82·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Simulating and executing the operation
3.2 Simulating and executing the operation
All the operations or cycles have 2 work modes; execution and editing.
• Press [ESC] to switch from editing mode to execution mode.
• Press [ESC] to switch from executing mode to editing mode.
For further information on simulating and executing cycles, see the chapter "7 Execution and
simulation".
The operation or cycle may be simulated in either mode. To do that, press the
[GRAPHICS] key.
To execute the operation or cycle, select the execution mode and press [START].
>
/<
]
[
X
AR
EY
Z
J"
F
NÑ
S
Q!
T
Editing mode Execution mode
15:28:42
Coordinate (Xi, Zi)
X 0.0000 Z 0.0000
Z
X

Xf, Zf
Xi, Zi


Coordinate (Xf, Zf)
X 0.0000 Z 0.0000
Diameter

0.0000
Safety distance
X 0.0000 Z 0.0000
TURNING CYCLE 1
X 00044.000 Z -00397.490
F 1.000 S 150 T 3
F 0.000 S 150 T 3
ROUGHING ROUGHING PASS

0
F 0.000 S 150 T 3
FINISHING FINISHING STOCK

0
RPM
GEAR
SMAX 1230
2
15:28:42
Coordinate (Xi, Zi)
X 0.0000 Z 0.0000
Z
X

Xf, Zf
Xi, Zi


Coordinate (Xf, Zf)
X 0.0000 Z 0.0000
Diameter

0.0000
Safety distance
X 0.0000 Z 0.0000
TURNING CYCLE 1
F 0.000 S 150 T 3
ROUGHING ROUGHING PASS

0
F 0.000 S 150 T 3
FINISHING FINISHING STOCK

0
RPM
GEAR
SMAX 1230
2
GRAPHICS