Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; 3.11.4 Definition of geometry levels 1 and 2. ZX profile

·160·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Profiling cycle
3.11.4 Definition of geometry levels 1 and 2. ZX profile
Outside or inside profile.
When changing the type of profile, the CNC changes the icon and shows the corresponding help
screen.
Work quadrant.
Type of machining.
When changing the type of machining, the CNC changes the icon and shows the corresponding
help screen.
In paraxial machining you must define the feedrate (F) for the tool to penetrate into the valleys. The
machining feedrate will the one indicated in the roughing and finishing windows.
In pattern repeat, the amount of stock to be removed from the original stock (
) must be defined.
That value is defined in radius.
To select the type of profile, place the cursor over this icon and press the two-color key.
Inside profile.
Outside profile.
The work quadrant is defined with the following icons: To select the desired type, place
the cursor over this icon and press the two-color key.
The type of machining is defined with the following icons: To select the desired type, place
the cursor over this icon and press the two-color key.
Paraxial machining.
Machining following the profile