Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; Type of taper.; Shape of the part before and after the taper section.; Work quadrant.

·104·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Taper turning cycle
3.6.1 Definition of data
Type of taper.
When changing the type of taper turning operation, the CNC changes the icon and shows the
corresponding help screen.
Shape of the part before and after the taper section.
When changing the type of section, the CNC changes the icon and shows the corresponding help
screen.
Work quadrant.
To select the type of taper turning operation, place the cursor over this icon and press
the two-color key.
Inside taper.
Outside taper.
The type of section before and after the taper section is defined with the following icons.
To select the desired type, place the cursor over this icon and press the two-color key.
The work quadrant is defined with the following icons: To select the desired type, place
the cursor over this icon and press the two-color key.
*
*
Z
X
Z
X
*
X
Z
X
Z