Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·153·
Drilling and tapping cycles
3.10.5 Multiple threading cycle. Basic operation
The machining steps in this cycle are as follows:
1. If the spindle is working in open loop (RPM or CSS mode) the CNC stops the spindle and
performs a home search on the spindle (Io).
2. If the operation has been programmed with another tool, the CNC will change the tool and will
move to the change position if so required by the machine.
3. The CNC starts the live tool at the selected speed and in the indicated direction.
4. Orients the spindle at the angular position for the first hole (indicated by
).
5. The tool approaches in rapid up to the starting point, keeping the safety distance selected
according to axes X and Z.
6. Tapping of the part in work feedrate F, until the depth L is reached.
7. Reversal of the turning direction of the live tool.
8. Withdrawal in work feedrate to the approach point.
9. Depending on the value assigned to parameter N (number of holes), the CNC repeats the
following steps N times.
The spindle moves to the next drilling point (angular increment ).
Repeats the drilling movements indicated in steps 6, 7 and 8.
10.Once the operation or cycle has ended, the tool will return to the position it occupied when calling
the cycle; i.e. to the point where [START] was pressed.
When executing an entire part, combination of operations or cycles, the tool does not return to
that point after executing each cycle.
11.The CNC stops the spindle, but it keeps the machining conditions set; tool (T), feedrate of the
axes (F) and spindle speed (S).
General logic output "TAPPING" (M5517) stays active while executing the cycle.
Tapping (with a clutch).
Rigid tapping. The spindle must have a servo-motor-drive system and an encoder.
To Next Page
Loading...
