Fagor 8055i FL EN - OPERATING IN JOG MODE; 2.1.2 Description of the special screen of the TC mode

·36·
Operating manual
CNC 8055
CNC 8055i
2.
OPERATING IN JOG MODE
·TC· OPTION
SOFT: V02.2X
Introduction
2.1.2 Description of the special screen of the TC mode
The special screen of the TC mode offers the following data:
1. Clock.
2. This window may show the following data:
SBK When "single block" execution mode is selected.
DNC When the DNC mode is active.
P..... Number of the program currently selected.
Message "In position" - "Execution" - "Interrupted" - "RESET".
PLC messages.
3. This window shows the CNC messages.
4. This window shows the lines of the program currently selected.
5. The X, Z, C axes have the following fields:
The spindle (S) has the following fields:
The auxiliary axes only show the real current position of the axis.
Being the X-C plane active, the coordinates shown in the "Actual" field correspond to the
transformed coordinates; not to the machine coordinates.
COMMAD It indicates the programmed coordinate or position that the
axis must reach.
ACTUAL It indicates the actual (current) position of the axis.
TO GO It indicates the distance which is left to run to the
programmed coordinate.
FOLLOWING ERROR Difference between the theoretical value and the real value
of the position.
THEORETICAL Programmed theoretical S speed.
RPM Speed in rpm.
M/MIN Speed in meters per minute.
FOLLOWING ERROR When working with spindle orientation (M19), it indicates
the difference between the theoretical and the real speeds.
15:28:42 SBK P000002 IN POSITION
M0
(MSG " " )
(IF P102 EQ 1 GOTO N10)
(IF P101 EQ 0 RET)
M3
(RET)
N10 M4
(RET)
G01 G18
M41
PARTC : 000000
CYTIME : 00:00:00:00
TIMER: : 000000:00:00
COMMAND
X 00020.000
Z 00089.520
C 00014.480
U 00025.000
THEORETICAL
ACTUAL
X 00020.000
Z 00089.520
C 00014.480
RPM M/MIN
TO GO
X 00000.000
Z 00000.000
C 00000.000
X 00000.000
Z 00000.000
C 00000.000
FOLLOWING ERROR
S 0.0000 S 0.0000 S 0.0000 S 0.0000
B 00000.013
1
2 3
4
5
6
87