Operating manual
CNC 8055
CNC 8055i
OPERATING IN JOG MODE
2.
·TC· OPTION
SOFT: V02.2X
·37·
Introduction
6. This window shows the status of the "G" functions and the auxiliary "M" functions that are active.
Likewise, it shows the value of the variables.
7. Reserved.
8. Reserved.
Displaying the active PLC messages
At the screen, press [+] of the alphanumeric keyboard, the CNC shows a window with all the active
PLC messages. Besides, this window is also displayed whenever there is a program in execution.
The [] [] [PAGE UP] [PAGE DOWN] keys are used to move around the messages. The [ESC]
key is used to close the window.
The window is only displayed when there are more than one active message.
Direct access to the oscilloscope
The oscilloscope may be accessed from the auxiliary screen by pressing "7" and then "1" as long
as no data is being written into any field.
PARTC It indicates the number of consecutive parts executed with the same part-
program.
Every time a new program is selected, this variable is reset to "0".
CYTIME It indicates the time elapsed while executing the part. It is given in "hours:
minutes: seconds: hundredths of a second" format.
Every time a part-program execution starts, even when repetitive, this variable
is reset to "0".
TIMER It indicates the count of the timer enabled by PLC. It is given in "hours: minutes:
seconds" format.
To Next Page
Loading...
