Fagor 8055i FL EN - OPERATING IN JOG MODE; Displaying the active PLC messages; Direct access to the oscilloscope

Operating manual
CNC 8055
CNC 8055i
OPERATING IN JOG MODE
2.
·TC· OPTION
SOFT: V02.2X
·35·
Introduction
Here are all the possible cases.
6. This window shows, in large characters, the selected tool number "T" and, in small characters,
the "D" offset associated with the tool. If the tool number and the offset number are the same,
the CNC will not show the "D" value. The window also shows a drawing of the location code
(shape) associated with the tool.
This window also shows the coordinates of the tool change point referred to machine reference
zero. The CNC does not show this window when text 47 of program 999997 has not been defined.
7. This window shows everything related to the spindle:
The theoretical turning speed that is selected; "S" value when constant turning speed and "CSS"
value when working at constant surface speed.
The spindle status. It is represented with an icon and may be turning clockwise, counterclockwise
or stopped.
The % of spindle speed being applied.
The maximum spindle rpm.
The active spindle speed gear (range). The CNC does not show this data when text 28 of program
999997 has not been defined.
8. Spindle angular increment when working in spindle orientation mode.
9. When accessing a work cycle, this window shows the help text associated with the selected icon.
That help text must be defined in program P999997 and edited in the desired language. See
chapter "1 General concepts".
10.Reserved.
Displaying the active PLC messages
At the screen, press [+] of the alphanumeric keyboard, the CNC shows a window with all the active
PLC messages. Besides, this window is also displayed whenever there is a program in execution.
The [] [] [PAGE UP] [PAGE DOWN] keys are used to move around the messages. The [ESC]
key is used to close the window.
The window is only displayed when there are more than one active message.
Direct access to the oscilloscope
The oscilloscope may be accessed from the standard screen by pressing "7" and then "1" as long
as no data is being written into any field.
100
10
1
100
10
1
1000
10000
JOG
100
10
1
100
10
1
1000
10000
JOG
100
10
1
100
10
1
1000
10000
JOG
100
10
1
100
10
1
1000
10000
JOG
100
10
1
100
10
1
1000
10000
JOG
100
10
1
100
10
1
1000
10000
JOG
15:28:42 IN POSITION
X
Z
S
00044.000
-00443.331
115
TO GO X 0000.000
TO GO Z 0000.000
F 0100.000
% 080
S 0100
% 115
SMAX 1000
RANGE 1
T 02
D 12
CHANG E POSITION
X 25.000 Z 85.000
F 0100.000
% 080
x10
F 0100.000
% 080

100
F 0100.000
% 080