CNC 8055
CNC 8055i
·TC· OPTION
SOFT: V02.2X
5
·181·
OPERATING IN ISO MODE
The ISO mode is accessed with the [ISO] key.
• When operating with operations or cycles, press the [ISO] key once.
• When operating in jog mode, press the [ISO] key twice; the first time to access the MDI mode
and the second time to access the ISO mode. See "2.11 ISO management" on page 72.
Cycle levels
The ISO mode offers several editing levels. Each level has its own screen and the main window of
the cycle indicates, with tabs, the available levels and which one is selected.
Simulating, executing or saving ISO cycles
Once the cycle data or the blocks have been edited, press [ESC]. The upper right side of the screen
will show the "start" symbol. From this moment one, the edited blocks may be simulated, executed
or saved like any operation or cycle.
• To simulate the blocks, press the [GRAPHICS] key.
• To execute the blocks, press the [START] key.
• To save the edited blocks, press the [P.PROG] key.
It is possible to combine ISO-coded blocks with standard and/or user machining cycles to create
part-programs. See chapter "6 Saving programs".
To change levels, use the [LEVEL CYCLE] key or the [page up] and [page down] keys to scroll up
and down through the various levels.
Block editing Scaling factor
Zero offsets and presets Work zones
Insert labels and repetitions
from label to label
Mirror image
To Next Page
Loading...
