Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; Level 4. Face grooving with incline walls.; Level 5. Cut-off.

Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·137·
Grooving cycle
The following data must be defined:
• The coordinates of the first and last points.
• The final diameter.
• The Inclination angles of the incline walls.
• Number of grooves and offset.
Level 4. Face grooving with incline walls.
The following data must be defined:
• The coordinates of the first and last points.
• The coordinate of the bottom of the groove.
• The Inclination angles of the incline walls.
• Number of grooves and offset.
Level 5. Cut-off.
The following data must be defined:
• Coordinates of the starting point.
• The final diameter of the cut-off.
• The intermediate diameter to decrease the feedrate.
• The cut-off feedrate.
Z
X

Xf, Zf
Xi, Zi

T
R


2
3
1
4
Z
X
Xi, Zi

f
T

r
F
Fr