Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; Work quadrant.; Coordinates of the theoretical corner or coordinates of the first point (Xi, Zi) and of the last point (Xf, Zf).; Safety distance.

Operating manual
CNC 8055
CNC 8055i
WORKING WITH OPERATIONS OR CYCLES
3.
·TC· OPTION
SOFT: V02.2X
·111·
Rounding cycle
Work quadrant.
Coordinates of the theoretical corner or coordinates of the first point (Xi, Zi) and
of the last point (Xf, Zf).
The coordinates are defined one by one. After placing the cursor on the coordinates of the axes to
be defined, the value is entered in one of the following ways.
• Entering the value manually. Key in the desired value and press [ENTER].
• Assign the current machine position.
Jog the axis with the handwheel or the JOG keys up to the desired point. Press [RECALL] so
the selected data assumes the value shown in the top right window and press [ENTER].
The top right window shows the tool position at all times.
Rounding radius (R).
Place the cursor over this data, key in the desired value and press [ENTER].
Safety distance.
In order to prevent collisions with the part, the CNC allows a part approach point to be set. The safety
distance indicates the position of the approach point referred to the theoretical corner.
To change one of these values, place the cursor on the corresponding data, key in the desired value
and press [ENTER].
The value of the safety distance on X is always defined in radius.
The work quadrant is defined with the following icons: To select the desired type, place
the cursor over this icon and press the two-color key.
*
X
Z
X
Z
Z
X
Xi, Zi
X
Z
Z
X
Xi, Zi
Xf, Zf
X
Z