Fagor 8055i FL EN - WORKING WITH OPERATIONS OR CYCLES; Machining direction.; Finishing stocks in X-Z.

·112·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING WITH OPERATIONS OR CYCLES
·TC· OPTION
SOFT: V02.2X
Rounding cycle
Machining direction.
When changing the machining direction, the CNC changes the icon and shows the corresponding
help screen.
Finishing stocks in X-Z.
Either a single residual stock may be defined that is applied depending on the cutter's edge or 2
different ones, one for each axis (X, Z). It is selected with the following icon located in the finishing
area.
• The figure on the left applies a finishing stock depending on the cutter's edge. The finishing stock
is measured on the tool's cutting edge.
• The figure on the right lets define 2 finishing stocks, one per axis, regardless of the type of tool
used.
The machining direction (turning direction or facing direction) is defined with the following
icons. To select the desired type, place the cursor over this icon and press the two-color
key.
To select the type of finishing stocks, place the cursor over this icon and press the two-
color key. To define these residual stocks, place the cursor on the corresponding data,
key in the desired value and press [ENTER].
*
Turning direction Facing direction
Z
X
Xi, Zi

1
2
3
4
5
Z
X
Xi, Zi

12
3
4
5


0
 x 0
 z 0
X
Z
*